How to charge
• Easy to charge via Micro 5pin USB port. When the battery indicates that is full, disconnect the wire. Never leave connected for nighttime.
How to fill
Top E-liquid Filling: The e-liquid can easily be filled by unscrew the top cap and pour liquid into the side hole (never to the center one). Please let the tank stand for 5 minutes, so the cotton can be saturated with juice before using.
Note:
1. Please don’t add e-liquid into the air pipe.
2. Please don’t overfill and make sure the e-liquid level is between 10%-90%.
3. Please first drip a few drops of e-liquid directly into the wick of the coil to make it fully saturated before first use.
4. Please use proper PG/VG ratio liquids for this type of tank
How to fit / exchange coil
1. Make sure the clearomizer is detached from the battery.
2. Turn the clearomizer upside-down, so that the mouthpiece is pointing towards the floor.
3. Unscrew the base of the clearomizer (the part that screws into the battery).
4. Unscrew the coil from the device and swop with new one
5. Screw the base with new coil back onto the clearomizer body.
6. Now is the time to fill the tank with liquid. Let the tank stand for 5 minutes, so the cotton can be saturated with vape juice before using.
7. Screw the clearomizer onto your battery.
Sub ohm device. Worth reading before buying:
This type of device is intended for the user with grater knowledge and experience. Coils used are below 1.0 ohm so that higher Wattage could be used. Before you use please read manual. Often, this kits are equipped with additional options that allow you to adjust Wattage.
For Sub ohm devices we recommend that you do not use liquids with nicotine higher than 6mg / ml and only good quality liquids with 30/70 PG / VG or higher VG. Devices of this type produce a lot more of vape, which results in a stronger hit to the throat (like higher nicotine in the basic device). Ask if you're not sure ... we don't bite ;-)
The kit contains:
• 1 x LUXE S mod
• 1 x SKRR Sub-Ohm Tank (2ml)
• 1 × QF Strip Coil 0.15Ω (Pre-installed)
• 1 × QF Meshed Coil 0.2Ω
• 1 × Silicone Case
• 1 × O-Ring
• 1 × USB Cable
• 1 × User Guide